Attention! The contents of this site cannot be printed. Please contact us for a hard or electronic copy

BDS^® PM-6652 is a unique, easy to handle liquid designed to provide broad spectrum control of bacteria, fungi, algae and yeasts that cause slime formation in paper mills.

• Fast kill minimizes quality problems

BDS^® PM-6652 provides exceptionally fast microbial kill rates, faster than virtually any other slimicide.

When the first signs of microbial contamination (pinholes, fisheyes) appear in finished paper BDS^® PM-6652 can be added to the pulpstock to arrest a minor contamination problem before it becomes more serious.

 

• Works at exceptionally low concentrations

In addition to quick action, BDS^® PM-6652 gives effective action at very low concentrations. In laboratory tests, based on ASTM E 600-77 (Efficacy of Slimicides for the Paper Industry / Bacterial), at all three pH levels tested, BDS^® PM-6652 yielded 99.999% kill of the test organism at only a fraction of the concentration of competing slimicides.

 

• BDS® PM-6652 minimize environmental concerns

Perhaps most important, BDS^® PM-6652 offers an unsurpassed increasingly strict environmental regulations governing their industry.

To begin with, BDS^® PM-6652 is used in low concentrations. And unlike other mill slimicides, they exhibit fast degradation to carbon dioxide, ammonia, and bromide ion, all of which are considered innocuous in the environment at the low levels encountered.

 

• Meets FDA requirements

BDS^® PM-6652 meets the requirements of the Food and Drug Administration (FDA) for use as a slimicide in the manufacture of paper and paperboard intended to contact food when used at a maximum level of 0.1 lb 2,2-dibromo-3-nitrilopropionamide (active ingredient of BDS^® PM-6652) /ton of dry paper.

 

You can feed BDS^® PM-6652 with a metering pump at any point where uniform mixing can be attained. Use corrosion resistant equipment.

Typical addition points are the beaters, jordan inlet or discharge, broke chests, furnish chests, save-alls, and/or white-water tanks.

In addition, BDS^® PM-6652 can be added prior to contaminated areas in the system.

BDS^® PM-6652 can be added continuously or periodically, with adjustments in the intervals between additions and dose levels dependent on visual inspections, microbiological analyses, and/or experienced observations of a water treatment representative.

 

• Treatment levels

For the control of bacterial, fungal, and yeast growth in pulp, paper, and paperboard mills, add BDS^® PM-6652 at the rates of 20 to 130 gr / tn of dry paper.

 

• Avoid breathing vapours.

• Wear suitable protective gloves and safety goggles. In case of contact immediately flush with water. After eye contact seek medical advice.

• Small spills can be flushed with water. Large spills should be collected for disposal.

• Read carefully the Material Safety Data Sheet (MSDS) before use.

 

Transport classifications

A.D.R. : 6.1 - 25c

IMDG : 6.1 - 6270-1

U.N.nr. : 2810 – III

Symbol : Xn, harmfull

R-phrases : 20/22, 41 38

S-phrases : 26, 28, 36/37/39, 45

 

Packaging

BDS^® PM-6652 is packed in 30 kg jerrycans and 240 kg PE drums.

Select a link below to continue, or go to the table of contents

[ Main ] [ Up ]